First phase of the project is about to begin. Been searching for parts and builds and finally got it together. Only thing I have to build wifeys before I build mine or I will never get any peace. Plus I will get a chance to practice on hers before I go full force on mine. Lol
” width=“666” height=“500”>
Looks cool. Where did you get the motor mounts?
Also, what motors do you have there? Where did you get them?
knew this was you when I saw the emoji in the title
380kv??? Thats way too much
Where did you get those wheel pulleys?
Thats totally cool!
Damn, I gotta do my own parts hunting! Lucky dog!! LOL
Just to note, you can’t do series with this because the motor you have is rated up to 10s. I would also recommend getting new motors anyways because those are 370kv, which is FAR too much for our application.
they’re 270, he linked the wrong motors.
@XvDarkVAngelvX have your better half look at these
KV (rpm/volt) : 270
Power (W) : 1820
Wire Winds : 9
Resistance (Kv) : 42
Idle Current (A) : 1.5
ESC (A) : 80
Cell NiMH/NiCD : 9-24
Cell LiPo : 3-8
D (mm) : 49.2
L (mm) : 65
Shaft (mm) : 8
Weight (g) : 435
the distance between the mounting holes is 30MM
ESC Supported: Sensored/Sensorless Brushless Motor ESC
The motors have 270kv on them. I have to find out wheather or not if they can be used. Will I have to use something else?
If the motors don’t fit. I’ll do a diagonal dual drive.
It will be fine…for sure u will need to dd because of the can size
I just ordered one to play with
What board are you going to put them on?