My Flipsky 6.6 dual mini was working fine yesterday. I changed some motor parameters and suddenly my motors are not working together. When I go to motor setup in vesc tool, only the motor corresponding with the side of the board that I’m plugged into is recognized. It’s almost as if the can connection is not being sensed. I can setup both motors separately, but not together. I’ve updated firmware on both sides of the board to no avail. Each side of the esc is being recognized as a master with no slave. Any help would be greatly appreciated.
1 Like
I’d contact Flipsky themselves. They will get back to you in under 24 hours.