Flux Linkage Detection Failed - Can’t Find Clear Solution

I recently booted up my skateboard to find that the motor would not spin at all in response to any movement on the remote. I went into the VESC tool to try to troubleshoot and got “Flux Linkage Detection Failed.” I tried basic troubleshooting - redoing it, turning on and off, restarting VESC tool, switching phase wires etc. I checked the solders on the motor phase wires as I did those myself, but they seem solid. Any time I run motor detection the motor gives a loud squeal, does nothing, then I get the error. Any ideas?

2 Likes