HELP NEEDED: VESC Settings

ESK8 Electronics
#1

Just like the heading states, needing some help w the VESC settings I’m needing to input, and any help would be greatly appreciated. Here’s the specs:

  • FOCBOX Unity
  • 8s1p (2 - 4s lipo packs) Turnigy Graphene 10.0Ah 15C
  • 2 - 6354 Janux Flux Drive 190kv motors (rated at 80A)
  • Gearing 15T/66T 200mm wheels

Thanks in advance

1 Like
#2

If i remember, it would be on start up foc mode:

Battery: 8s 10.000 mah

Motor: 15T motor pulley, 66T wheel pulley

And then after the initial setup, it would be

Motor max: no higher than the max the esc can give out (-5 amps for safety).

Motor regen max: same as motor max but in negative.

Battery max: 15 x 10 = 150A (put 60A each esc side if dual)

Battery max regen: you decide (this is your brake. You might not need it to be over -20A each side).

That’s basically it. Everything else should be fine.

#3

Okay, I’ll give it a try. Thanks for the response!