Starting Tips | Ask Questions | Introductions | Categories

How to wire my BDUAV 6384-120kv motor

I’m new to brushless motors. I’ve purchased a BDUAV 6384-120kv brushless sensored motor (https://www.amazon.de/gp/product/B07Q75BCQJ/ref=ppx_yo_dt_b_asin_title_o01_s00), It arrived without documentation, schematics, or a wiring diagram - so I’m at a loss as to how to wire it to a controller board.

It has three large wires colored red, black, and blue. 5 smaller wires attached to a Berg connector (red, yellow, white, orange, black - in that order)

I’m not sure which wires are the A, B, C; which are power/sensors, or what controller board I could use. I don’t need a remote, just a controller board with an on/off and a potentiometer-style speed (voltage) control.

If anyone can offer advice, or link me to a wiring diagram - that would be greatly appreciated.

The 3 big wires are the power you plug it to the 3 big wires on the ESC if you have a VESC you can change the direction directly in the VESC tool. the smaller wires are the sensor wires(not really necessary to run the motor but it’s better). It looks like a flipsky motor or a copy of one. for a VESC i would recommend either a flipsky or a focbox as i don’t really know any other VESC company and flipsky has an accessory to monitor speed battery level and whatnot https://flipsky.net/collections/accessories/products/tft-screen-ver2-module-based-on-vesc?variant=33929312206983

Hi joshoujoe,

Thanks for the response. This was my thought as well, based on this … https://www.youtube.com/watch?v=wS80cLQZ338 … but I thought this wiring was only for non-sensed motors (if I’m wrong about that, please correct me.) In the vid, he implies that the three wires go into the ESC and are individually powered for the rotors - and the Berg connector can just be ignored.

The seller did respond to an email with this image…

…showing a positive and negative power on the Berg. And it lists the A, B, C as living on the berg too. He didn’t discuss what the three big wires at all, he just sent the wireouts for the Berg connector.

Sorry for (still) being so confused :slight_smile: But thanks again for the help!

so the 3 big wires connect tot the 3 other big wires from your ESC

if you have a cheap ESC your 3 big motor wires will most likely be 3 different color it doesn’t matter wich way you plug it in. but the sensor wires can infact be ignored.

1 Like