October 28, 2017, 1:08pm
@ShutterShock hehe it’s not only two vesc on one board but also bit more power handling.
Yesterday I received some electronic parts two dev boards one for the remote and another for main cpu of the board. The tracking number from trampa order says it should arrive today so I am waiting for board parts in the time I am sitting on PBC
October 28, 2017, 1:16pm
Another update (I hate that I have to switch from macOS to Windows)
Looks really interesting. Following this!
October 28, 2017, 4:51pm
This shipping company likes to tease me…
October 29, 2017, 12:16am
So apparently currier was not able to reach my home or etc
I was working on ESC design and went from dual on board to two separates too much struggle to fit everything. The power stage is done. All is left to design control board.
October 30, 2017, 7:54pm
After waiting whole weekend for packages today they arrived.
First let’s start with APS 6384S 170kv small fiddle spinners…
Compared to my Evolve GT 50mm motors.
They are freaking huge (The size of my fist…) Let’s start with the big package
HolyPro 35º deck
Mounting the trucks and wheels
Tried to inflate the tires… One tire is punctured. I guess when building hub it pressed the tire in between… Ech no try out today.
So here how it looks compared to Evolve Carbon GT AT
So next steps are to finish electronics and get the motor mounts finished.
October 31, 2017, 8:36pm
Here is power stage for this project. I should finish logic side today and order pcb by the end of week.
Post some photos of that direct drive when ya get a chance
October 31, 2017, 10:11pm
Yeah, waiting for the parts to arrive and then will update on progress
November 1, 2017, 4:27am
Finished PCB for VESC will be sending to manufacture by the end of the week.
So this is a double VESC that supports a lot more current than the normal one?
November 1, 2017, 10:28am
Not really. This is single and it’s single mosfet setup (basically same as vesc but without drv) First one to make board for my motors then to experiment
Huh interesting. Sounds neat
November 1, 2017, 8:57pm
How is it driving the mosfets without the drv ?
Mosfet drivers most likely
November 1, 2017, 9:06pm
@SORRENTINO is correct good old Mosfet gate drivers
Are you writing code from scratch?
November 1, 2017, 9:10pm
No it’s based of Vesc6 just bit modified