New Board has no Power

I just finished putting together my board and I can’t figure out why it has no power. Parts I used:

Sk3 190kv 63mm motor VESC Two Zippy 5000mah 25c batteries Torque boards remote

The batteries are charged and the motor will spin but has almost no power. (not enough to push the board by itself) The Vesc has not been programmed aside from the factory settings.

Any ideas??

maybe this can help…

1 Like

program your vesc, my build is very similar and it works no prob after calibration

Okay sweet thanks! I’ll post an update soon.

It’s almost definitely your voltage cut off levels…

How many cells in series do you have?

Changed the cut off values and it runs beautifully.

2 Likes

Thought so… :thumbsup:

1 Like