Successful motor setup but shuttering when triggered

ESK8 Builds
1

Hi there, up until recently my board was working fine. Hadn’t used it for about two months and notice one motor would jolt so I re-ran the calibration tool. Now I get issues with shuttering on both motors and the VESC motor setup provides different results each time. Sometimes motors do not work, other times one works. I am at a loss as to what the issue is. Any help would be greatly appreciated.

Video link: https://youtu.be/FIY0uVtCTVk

3 Likes
2

Are you sensord?

Unplug sensors.

1 Like
3

Thank you, Crisfell. That appeared to give me some progress; however, the motors are not spinning anywhere near as fast as they should.

1 Like
4

What happens when you are riding. Sensorless Motors never tend to run well on bench uploaded

1 Like
5

Run motor detection without the sensors.

1 Like