The MasterCho Enclosure

I was playing with the program :stuck_out_tongue_winking_eye:


I don’t know much about what to do with the rail indentations.

1 Like

That looks good, I can do some measurements tomorrow if you tell me what you need. Not sure how to incorporate, avoid, or ignore the grab rails. Can also post a picture of existing build with temporary Tupperware enclosure lol


@Airmacx, Is this a thread that shows Mastercho’s enclosures? :scream: Can I post some pictures here?

Sure thing.

1 Like



love those hydrographics !

1 Like

I have been asked. I have only two sizes(23" and 13" tall)available to make.


New design coming.


Nice! Look forward to your future designs. When I got the enclosure I was amazed, but I’ve never worked with something like it. How might I go mounting it to my board? Will using a normal hand drill do just fine? What screws would you recommend?

Thank you. Yes,the hand drill should work and I would use T-nuts with M4 screws and rubber washers.

It’s called " Home appliance EPDM rubber washer "

1 Like

Man sure this is posted already, but what are the width and height dimensions for the 23" and 13"? And dimensions for the design 3 to come? Thx

Design 3 mold will be available next week to do Resin Infusion.

Hope it helps. :relaxed:


Do you have a price list?

And also, what’s the website?

$75 for the 13 inches long. $100 for the 23 inches long.:relaxed:


No, I don’t. I guess this is the place to look from now on .:wink:


tight fit, just checking are the dimensions for enclosure include the flange, so external measurements? Also, can you do anything in white or white carbon fiber (which I did not know was a thing )?

Yes, that’s external measurement. If anything shorter than that 10S4P with other electronics won’t fit in.

I know there is Silver Barracuda Fabric – 3k, Aluminized Glass which is the closest you can get for the color you are looking for. But it’s going to be a special order.

1 Like

I found better picture of the fabric.

1 Like