VESC tool setup

ESK8 Electronics
1

Hello all, sorry to bother you guys but I just wanted a quick opinion on my setting for my board and to see if I can improve performance and or safety! By the way my setup is: 12s4p on samsung 30qs 192kv sk3 6374 ( Max Loading: 80A Max Power: 4032W ) 97mm flywheels 36T/18T ratio 345mm belts 12mm 5M 218mm trucks image

image

image

image

![image|493x499]

image (upload://vZA8I1IShXatUZQuF5D22CVdP6L.png)

image

2

Your motor doesn’t have hall sensors so change to bldc mode. your motor settings are fine, just expect a shit load of torque. i personally would up the battery amps to 30a. id make the battery cutoff start at 40.8V, and the cutoff end to 38.4V, just helps with longevity of the pack a lil