Hi, I recently purchased some new Caguamas and wanted to replace the stock wheels on my boosted board. However, I cannot seem to get the black gear/pulley component out of the rear wheels. I have searched through all threads and tried oil, screwdriver, etc. It does not seem to budge after I went at it for ~30 minutes. Can anyone help, I don’t want these new wheels to go to waste?
pretty sure its a press fit pulley… so just use a bigger hammer.
How would I use the hammer?
Well its kinda a figure of speech…
i think you might need to bearing puller.
I don’t mean the bearing, I mean the thing the belt goes around.
How about you share a picture and ill draw a solution for ya